Epson 955WH User's Guide download pdf (Page 65)

Setting Up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management Protocol) software on network

computers so they can monitor projectors. If your network uses this software, you can set up the

projector for SNMP monitoring.

1. Press the Menu button.

2. Select the Network menu and press Enter.

3. Select Network Configuration and press Enter.

4. Select the Others menu and press Enter.

5. Enter up to two IP addresses to receive SNMP notifications, using 0 to 255 for each address field.

Note: To enter the IP address using the numeric keys on the remote control, press and hold the

Num button. Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x

is a number from 0 to 255).

6. If available, select the Priority Gateway setting for your network.

7. If your network environment uses an AMX controller, turn on the AMX Device Discovery setting to

allow the projector to be detected.

8. If your network environment uses a Crestron RoomView controller, turn on the Crestron RoomView

setting to allow the projector to be detected.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 241 242

No comments

Epson 955WH User's Guide Page 65