Epson ActionNote 880C User's Guide download pdf (Page 85)

Position the plastic strip above the keyboard and snap it into

place. The strip fits tightly, but it should not obstruct the

function keys.

Slide the plastic caps over the screws on each side of the case

below the screen and snap them into position. Make sure

you use the correct cap for the left or right side; they will

not slide into place on the wrong side.

After you have replaced the keyboard, check that the function

keys operate smoothly. If any of the keys tend to stick, repeat

the keyboard replacement procedure.

Installing a Memory Module

Your computer comes with 4MB of memory soldered on the

system board. If it has more than 4MB memory, it already has a

memory module installed. You can check the amount of

memory installed by running the Setup program. See “Running

the Setup Program” in Chapter 1 for instructions.

You can increase your computer’s memory up to 24MB by

installing a 4, 8, 16, or 20MB memory module.

Caution

The memory module can be easily damaged and is

expensive to replace; so if you don’t feel confident about

installing it yourself, ask your Authorized EPSON Servicer

for assistance.

If your computer already has a memory module installed on

the board, and you want to replace it with a higher-capacity

module, you need to remove the original memory module.

Follow these steps:

Remove the keyboard as described on pages 4-13 to 4-15.

4-16

Installing Optional Devices

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 138 139

No comments

Epson ActionNote 880C User's Guide Page 85