Epson Endeavor-WG Setup Guide download pdf (Page 40)

Setting the Built-in Paralllel and Serial Port Options

There are two sets of options you can use to control the

operation of your built-in parallel and serial ports: the primary

port options and the I/O address options. The primary port

options are listed under the

Ports

heading and the I/O

address options are listed under the

Port

configuration

heading. The table below lists the options and their available

settings.

The default setting for the parallel port and both serial ports is

Enabled

The default I/O address setting is primary for LPT1,

the parallel port, and COM1, the first serial port.

If you are using only the two primary ports, you do not need to

change any settings.

Running the SETUP Program

2-13

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

No comments

Epson Endeavor-WG Setup Guide Page 40