Epson Endeavor-WG Specifications Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Hardware Interrupts
IRQ no. Function
IRQ0
Timer output
IRQ1
Keyboard
IRQ3
Serial port 2
IRQ4
Serial port 1
IRQ5
Available (parallel port 2)
IRQ6
Floppy disk drive controller
IRQ7
Parallel port 1
IRQ8
Real-time clock
IRQ9
Available
IRQ10
Available
IRQ11
Available
IRQ12
PS/2 compatible mouse or optional pointing device
IRQ13
Math coprocessor
IRQ14
Hard disk drive controller
IRQ15
Available
System I/O Address Map
* Recommended addresses for installing devices
Jumper Settings
EPSON Endeavor WG
See the illustration on page 3 for the location of the jumpers
on the main system board.
CPU Speed Jumper Settings
CPU speed
IJl*
152’
153’ 154’
SX/33, DX2/66 (33 MHz)
jA
IA
jB
IA
DX2/50 (25 MHz)
]B IB IA
IA
* Factory setting according to processor external speed clock; do not change
these jumpers unless you replace a DX2/50 chip with a DX2/66 chip.
CPU Type lumper Settings
J5 J6 J7
J8
B B B
B
A A A
A
A
A
B B
CPU type*
486SX/33
ODP486-33 or 487SX/33
ODP486DX50/66
* Factory-set according to system type. You need to change jumpers
J5-J8 only if you have the 4SX/33 system and you remove the original
microprocessor chip and install a new one, or if you install a future
OverDrive processor in the 4DX2/50 or 4DX2/66.
Other Jumper Settings
Jumper
number
J9**
Jumper
setting
A*
Function
Enables the built-in mouse connector
J10
J11
J12**
B
A’
B
A’
B
A
Disables the built-in mouse connector
Enables the built-in VGA display adapter
Disables the built-in VGA display adapter
A color monitor is installed
A monochrome monitor is installed
Enables a mouse or other pointing device
Disables a mouse or other pointing device
Cl
* Factory setting
“To use a mouse connected to a port on an option card, set J9 to B and
J12 to A. lf you connect another type of pointing device (such as a joy
stick) to the option card port, set both jumpers to A.
EPSON Endeavor WG-6
5/3/93
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments