Epson R1400 Specifications Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
Epson Stylus Photo 1400
1/07 Epson Stylus Photo 1400 - 13
9. Remove the yellow tape from
the bottom of the ink cartridge.
Caution: You must remove the
yellow tape from the cartridge
before you install it; otherwise,
print quality may decline or you
may not be able to print.
Do not remove or tear the label or other seals on the cartridge;
this can cause leakage.
10. Place the new ink cartridge into the cartridge holder and
push it down until it clicks into place.
11. Replace any other cartridges that need to be replaced.
12. Close the cartridge cover.
13. Close the printer cover.
14. Press the H ink button. The printer begins charging ink.
The green P power light flashes and the printer makes noise.
Charging takes about two minutes. When it’s finished, the
green P power light stops flashing and stays on, and the red
H ink light goes out.
Caution: Never turn off the printer while the green P power light
is flashing, or you’ll waste ink.
Note: If the red
H ink light stays on, an ink cartridge may not be
installed correctly. Open the printer cover and press the
H ink
button two or more times. Then open the cartridge cover and press
down all the ink cartridges until they click into place. Close the
cartridge and printer covers, and press the
H ink button to charge
the ink.
Cleaning the Printer
To keep your printer working at its best, you should clean it
several times a year.
1. Turn off the printer, unplug the power cord, and
disconnect the USB cable.
2. Remove all the paper, then use a soft brush to clean the
sheet feeder.
3. If the outer case or inside of the sheet feeder is dirty, clean it
with a soft cloth dampened with mild detergent. Keep the
printer cover closed to prevent water from getting inside.
4. If ink accidentally gets inside the printer, wipe it off with a
damp cloth in the area shown below.
Warning: Don’t touch the gears or any other parts inside the
printer.
Caution: Never use a hard or abrasive brush, or benzine, alcohol,
or paint thinner for cleaning; they can damage the printer
components and case.
Don’t get water on the printer components and don’t spray or
apply lubricants, oils or grease inside the printer.
Don’t use any cleaning sheets included with special paper; they
may jam inside the printer.
Clean here
Page view 12
1 2 ... 8 9 10 11 12 13 14

Comments to this Manuals

No comments