Epson XP-300 User's Guide download pdf

5 Load paper against the right edge guide and behind the

tab line on the left edge guide, with the printable side

faceup.

8½ × 11 inch

(216 × 279 mm)

4 × 6 inch

(102 × 152 mm)

Note: Don’t load the paper sideways; always load it short

edge first.

6 Slide the edge guide over, against the left edge of

the paper.

7 Flip the feeder guard back.

Read these instructions before using your product.

Note for Spanish speakers/Nota para hispanohablantes:

Para obtener instrucciones de conﬁ guración en español, consulte la

Guía de instalación en www.epson.com/support/xp300sp (requiere una

conexión a Internet).

Unpack

Caution: Do not open ink cartridge packages until you are ready to

install the ink. Cartridges are vacuum packed to maintain reliability.

Remove all protective materials, including from inside the printer.

Turn on and adjust

1 Raise the paper support, then connect the power cord to

the back of the printer and to an electrical outlet.

Caution: Do not connect to your computer yet.

2 Raise the control panel, then press the power button.

Note: If you want to lower the control panel, squeeze the release

bar underneath.

Caution: Do not lower the control panel without first squeezing the

release bar underneath or you may damage the product.

3 To select English as your language, press OK.

If you want to change the language, press or to select

it, then press OK.

Note: You can change the language later using the product’s

control panel. For more information, see the online User’s Guide.

Install ink cartridges

Note: Don’t load paper yet.

1 Lift up the scanner unit, and wait until the ink cartridge

holder stops moving.

2 Shake the ink cartridges gently 4 or 5 times, then

unpack them.

3 Remove only the yellow tape from each cartridge.

Caution: Don’t remove any other seals or the cartridges may leak.

4 Insert the cartridges in the holder for each color, and press

each cartridge down until it clicks.

5 Lower the scanner unit.

6 Press OK to prime the ink delivery system. Priming takes

about 4 minutes.

Note: The cartridges included with the printer are designed for

printer set up and not for resale. After some ink is used for priming,

the rest is available for printing.

Caution: Don’t turn off the printer while it is priming or you’ll

waste ink.

Load paper

1 Flip the feeder guard forward.

2 Raise the paper support, if necessary. Then pull up the

extension and tilt it back slightly.

3 Pull out the output tray, then raise the paper stopper.

4 Slide the edge guide to the left.

*412494000*

XP-300 Small-in-One

™

Printer

Start Here

4124940 Rev.0

1-F C

4124940 Rev.0

1-F M

4124940 Rev.0

1-F Y

4124940 Rev.0

1-F K

1 2 3 4

Summary of Contents

Page 1 - *412494000*

5 Load paper against the right edge guide and behind the tab line on the left edge guide, with the printable side faceup.8½ × 11 inch(216 × 279 mm) 4

Page 2

5 Load paper against the right edge guide and behind the tab line on the left edge guide, with the printable side faceup.8½ × 11 inch(216 × 279 mm) 4

Page 3 - Any questions?

Connection optionsWireless connectionYou must install the software on every computer from which you want to print. For the ﬁ rst installation, we reco

Page 4

Connection optionsWireless connectionYou must install the software on every computer from which you want to print. For the ﬁ rst installation, we reco