1
Turn on your notebook.
2
Remove the projector’s lens cap.
3
Make sure the Power light
is orange and not flashing.
4
Press the Power button
to turn on the projector.
The projector beeps and
the Power light flashes
as the projector warms up.
Turn on your equipment
Connect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User’s Guide.
Epson
®
PowerLite
®
821p
Quick Setup
1
Locate the required cables:
2
Connect the computer cable to the
Computer 1/Component Video 1
port on the projector.
3
Connect the other end to your notebook’s video-out
or monitor port.
NOTE: If your notebook has a DVI connector, you need to either
connect a DVI-to-VGA adapter to the included computer cable (see
your computer’s documentation), or purchase an optional DVI to
VGA cable (for a higher-quality image). See your User’s Guide.
4
Connect the power cord to the
projector, then plug the other end
into a grounded electrical outlet.
Power cord Computer cable
Power light is orange
and not flashing
1
If you’ve turned on your notebook and you don’t see an image, press
the Source Search button on the projector repeatedly until you see
your image.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
Rotate the focus ring to sharpen the image.
3
Rotate the zoom ring to reduce or enlarge the image. (You can also
move the projector closer to or farther from the screen.)
4
If your image looks like or , you’ve placed the projector off to
one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
If your image looks like or , use the or buttons to
square up the image.
Zoom ring
to adjust the
image size
Focus ring
to sharpen
the image
Adjust the image
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice. The lamp turns off, the Power
light flashes orange (about 20 seconds), and the projector beeps
twice to signal power is off.
2. Once the projector beeps, it’s safe to unplug it.
Never unplug the projector when the Power light is green or
flashing orange.
Power button
Comments to this Manuals