AP-60Installation Guide
10Planning the InstallationHere are the basic steps required to install the AP-60. Allow at least 1 to 2 hours to complete the installation. Be sure t
11Required Tools and HardwareThe AP-60 should be installed by a professional audio/video installer or other qualified professional. To install the sys
12Locate the following parts:•IR dome sensor•Coaxial cableWarningMake sure that the ceiling is strong enough to support the IR dome sensor and coaxial
13Install the Mounting PipeWarningMake sure that the installed ceiling mount is designed to support the total weight of both the AP-60 and your projec
14Install the AP-60Locate the following parts:•AP-60•Lower bracket• M47.5 jam nut• M10 bolt and nut1 Locate the lower bracket and M47.5 jam nut and ha
155 Remove the two screws from the audio control panel.6 Gently remove the audio control panel from the AP-60 and keep it supported at all times.Warni
167 Insert the audio cables into the cable channel, then feed the cables through the audio control panel slot as shown below.8 Connect the audio cable
1710 Secure the two screws that hold the audio control panel in place.11 Attach the IR dome sensor cable to the top of the AP-60.12 Once the cables ar
1814 Attach the included guy wires to the AP-60 as shown below.15 Attach the guy wires to a secure location. Installation varies depending on your bui
19Install the ProjectorWhen installing a projector under the AP-60, make sure that all of the mounting hardware and guy wires are secured correctly. F
2Copyright NoticeAll rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by an
203 Reconnect the ends of the neck strap.Insert Batteries1 Remove the remote control battery cover.2 Check the battery label and insert the included R
215 Check the battery label and insert the included LR6 (alkaline) AA batteries into the pendant microphone.6 Close the pendant microphone’s battery c
224 Have an assistant wear the pendant microphone with the black emitter facing away from them.5 Adjust the neck strap so that the top of the micropho
2310 Have an assistant speak normally into the microphone and gradually increase the Microphone 1 gain control knob on the AP-60 until the notch on th
24Basic Operation ProblemsSound ProblemsProblem SolutionThe system doesn’t turn on. Press the P power button on the AP-60 remote control to turn the s
25Problems Using the Pendant MicrophoneProblems Using the Remote ControlProblem SolutionThe power light won’t come on. You may need to replace the pen
26Where To Get HelpInternet SupportVisit Epson’s support website at epson.com/support and select your product for solutions to common problems. You ca
Printed in XXX
3Important Safety InstructionsCAUTION: To reduce the risk of electric shock, do not remove the cover. No user serviceable parts inside. Refer servicin
4All safety and operating instructions should be read before using the system. After you have read all instructions, save this information for later r
5• Do not leave the system or the remote control with batteries inside a vehicle with the windows closed, in places where they will be exposed to dire
6• If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them immediately.• Replace the batteries as soo
7• Do not install this product where it may be subject to impact or vibration.• Do not install this product in direct sunlight or near a heater vent,
8ContentsIntroduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9IntroductionBefore installing the AP-60, you should perform the following steps:• Run all wiring required for the audio and power connections for the
Comments to this Manuals