Epson S1C33 Specifications download pdf (Page 18)

3 TARGET PROGRAM AND DEBUGGING

EPSON S1C33 FAMILY DEBUG MONITOR

OPERATION MANUAL

3.4 Debugging Method

The following three methods are available for debugging the target program.

1. Debugging in the ROM

Map the target program in the ROM after linking to the debug monitor. The target program can be executed and

debugged in the ROM.

Since the [Source] window of the debugger displays the disassembled content of the ROM on the target system,

it is not necessary to load the target program with the lf command. To display the source, load the same

absolute object file as the one written to the ROM. In this case, by using the ld command instead of the lf

command, the db33, except for the object code, loads only the debugging information.

After starting the debugger, follow the process below before starting to debug:

1. Load the debugging information (when displaying the source or using symbols).

2. Set up a hardware PC break point for the forced break function.

Example: command file example of the above description

ld sample.srf ; Load the debugging information of the target program

bh ESC ; Set up a hardware PC break point at the label ESC (for forced break)*

* For example, an NMI input switch can be used for the forced break function.

Example: NMI processing routine example for forced break function

NMI: ; nmi

nop

.global ESC

ESC: ; Label set as a hardware PC break point for the forced break function

reti

Note: When debugging the target program in the ROM, the software PC break function (bs command)

cannot be used.

2. Debugging in the RAM

Load the target program into the RAM of the target system with the lf command to debug the program in the

RAM.

After starting the debugger, follow the process below before starting to debug:

1. Set the trap table base address (only when placing the trap table in the RAM).

2. Load the target program.

3. Reset the CPU.

4. Set up a hardware PC break point for the forced break function.

The following shows a debug-command file example in which the above process is described.

Example: "dmt33004\sample\led.cmd"

eb 4812d ; Set up TBRP (TTBR write protection register)

59 ; Remove TTBR write protection

ew 48134 ; Set up TTBR (trap table base register)

600000 ; Set up the base address to 0x600000 (external RAM)

lf led.srf ; Load the target program (0x600000~)

rsth ; Reset the CPU (reset vector at 0x600000 is set to the PC)

bh ESC ; Set up a hardware PC break at the label ESC (for forced break)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Comments to this Manuals

No comments

Epson S1C33 Specifications Page 18

Comments to this Manuals

Related products and manuals for TVs & monitors Epson S1C33