Epson Equity LT-286e User Manual download pdf (Page 11)

Selecting Diagnostics Tests

This section describes the various ways you can select the tests

you want to run.

To start a single test, move the cursor to highlight the test

category on the main menu. Then move the cursor to the

submenu and highlight the test you want to perform. Press

Enter to start the test.

To select several tests at one time, move the cursor to each test

you want to perform and press F3. If you decide you do not

want to run a selected test, highlight the test name and press F3

again.

You can press F4 to select all tests for all devices, and press F5

to deselect all selected tests.

Once you select a test, it remains selected until you deselect it.

If you run a test or a group of tests and start testing again, DIAG

performs the same tests unless you deselect them.

You must enter certain parameters for the hard disk drive and

the diskette drive tests. If you use F3 to select these tests, DIAG

prompts you for the information. If you use F4 to select these

tests, DIAG prompts you for the information during the first

pass of the test. If you perform more than one pass of the test,

DIAG uses the same parameters for each pass.

Systems Diagnostics

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

No comments

Epson Equity LT-286e User Manual Page 11