Epson A882401 Technical Information Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
6 Introduction
Do not store the camera or its optional accessories near
sources of bright light, direct sunlight, high humidity,
heat, excessive dirt or dust, or where they will be
exposed to strong vibrations or magnetic fields.
Avoid sudden temperature changes, which can cause
moisture to condense on the camera. Keep the camera
in a case or bag if you need to move it from a cold
environment to a warm one. Allow time for the
camera and its optional accessories to adjust to
temperature changes before using them.
Use only the types of power sources listed in this User’s
Guide.
Do not use a frayed or damaged power cord.
If you use an extension cord with the optional AC
adapter, make sure the total ampere rating of the
devices plugged into the extension cord does not
exceed the cord’s ampere rating. Also, make sure the
total of all devices plugged into the wall outlet does not
exceed 15 amperes.
Remove batteries and/or unplug the camera and the
AC adapter and refer servicing to qualified service
personnel under the following conditions: If the power
cord or plug is damaged; if liquid has entered the
camera; if the camera has been dropped or its exterior
has been damaged; if the camera or its optional
accessories do not operate normally or exhibit a
distinct change in performance.
Adjust only those controls that are covered by the
operating instructions.
If the liquid crystal solution contained in the camera’s
control panel or in the screen on the optional EPSON
photo LCD Monitor leaks out and gets on your hands,
wash them thoroughly with soap and water. If it gets
in your eyes, flush them immediately with water.
If you plan to use the camera and its optional accessories in
Germany, observe the following:
To provide adequate short-circuit protection and over-
current protection for the products, the building
installation must be protected by a 16 amp circuit
breaker.
Bei Anschluß des Produkts an die Stromversorgung
muß sichergestellt werden, daß die Gebädeinstallation
mit einem 16 A-Überstromschalter abgesichert ist.
pc-int.fm5 Page 6 Friday, November 1, 1996 9:45 AM
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 143 144

Comments to this Manuals

No comments