Epson 2D/3D User's Guide download pdf (Page 118)

• Never allow objects of any kind to enter any openings in the projector. Do not leave objects, especially

flammable objects, near the projector. Never spill liquid of any kind into the projector.

• If you are using two or more projectors side-by-side, leave at least 2 feet (60 cm) of space between the

projectors to allow for proper ventilation.

• You may need to clean the air filter and vent. A clogged air filter or vent can block ventilation needed

to cool the projector. Do not use canned air, or the gases may leave a residue.

• Do not store the projector outdoors for an extended length of time.

• Except as specifically explained in this manual, do not attempt to service this product yourself. Refer

all servicing to qualified personnel. Opening or removing covers may expose you to dangerous

voltages and other hazards.

• Never open any covers on the projector except as specifically explained in this manual. Never attempt

to disassemble or modify the projector. Refer all repairs to qualified service personnel.

• Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the

following conditions: if it does not operate normally when you follow the operating instructions, or

exhibits a distinct change in performance; if smoke, strange odors, or strange noises come from the

projector; if the power cord or plug is damaged or frayed; if liquid or foreign objects get inside the

projector, or if it has been exposed to rain or water; if it has been dropped or the housing has been

damaged.

• Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.

• Unplug the projector when it will not be used for extended periods.

• Do not use the projector where it may be exposed to rain, water, or excessive humidity.

• Do not use or store the projector where it may be exposed to smoke, steam, corrosive gases,

excessive dust, vibration, or shock.

• Do not use the projector where flammable or explosive gases may be present.

• Do not use or store the projector or remote control in a hot location, such as near a heater, in direct

sunlight, or in a closed vehicle.

• If you use the projector in a country other than where you purchased it, use the correct power cord for

that country.

• Do not stand on the projector or place heavy objects on it.

• Do not use the projector outside of the required temperature range of 41 to 95 °F (5 to 35 °C). Doing

so may cause an unstable display and could lead to projector damage. Do not use or store the

projector where it may be exposed to sudden changes in temperature.

118

1 ... 117 118 119 ... 168

No comments

Epson 2D/3D User's Guide Page 118