Epson ActionPC 6000 User's Guide Page 95

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 94
Connecting the Drive and Power Cables
If you are installing a diskette or tape drive, follow all the steps
below. If you are installing a hard disk drive, follow the
instructions on pages 5-9 through 5-12. Then go to step 5 below.
Note
If you have one hard disk drive installed in the bracket
below the diskette drive and will install a second hard disk
drive in the external bay on the same interface, you need to
purchase a new hard disk drive cable that can reach both
drives.
1. Locate the diskette drive ribbon cable; the connector in the
middle is already connected to the system board.
2. If you are installing a drive with a card-edge connector, make
sure you align the key-way (the plastic divider) with the
gap in the drive connector, as shown below.
Installing and Removing Drives
5-19
Page view 94
1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 143 144

Comments to this Manuals

No comments