6-8
The paper and power lights are flashing
All the lights are flashing
The printer has finished charging the ink cartridge, but the power light is still flashing
The printer software installed with Windows 3.1 does not work correctly after you upgrade to
Windows 95
After you install your printing software, you see the Windows 95 New Hardware Found window
Possible cause Solution
A carriage error has occurred. Remove any paper in the printer. Press the
load/eject button for about
30 seconds. Then press it again. Turn the printer off, wait a few seconds,
and then turn it on and try printing again. If the error is not cleared,
contact EPSON as described in the Introduction.
Possible cause Solution
You haven’t removed all the
packing material from the
printer.
Remove the packing material, following the instructions on the Notice
Sheet in the box.
An internal error may have
occurred.
Turn off your printer, wait a few seconds, and turn it on again. If the lights
still flash or stay on, contact EPSON as described in the Introduction.
Possible cause Solution
The ink cartridge clamp isn’t
locked down.
Press down on the clamp to lock it into place.
Packing material remains in
the printer.
Remove the packing material, following the instructions on the Notice
Sheet in the box.
The printer needs to initialize. If the printer is not moving or making noise, but the light is still flashing
after 10 minutes, turn the printer off. If the light is still flashing when you
turn it back on, contact EPSON as described in the Introduction.
Possible cause Solution
Your printer software is not
set up correctly for Windows
95.
Reinstall the printer software after installing Windows 95, as described in
the Quick Setup booklet.
Possible cause Solution
An operating system error has
occurred.
Click Do
not
install
a
driver, and then click OK.
Comments to this Manuals