Epson EMP-82 User's Guide download pdf (Page 5)

iii

English

Enlarge Reduce

Normal

Wide Top

Wide Base

Extend Retract

Rear Adjustable

Foot

* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.

* For video equipment,

press "play" to start

playback.

Control Panel Remote Control

Power Indicator

Lit

Flashing

Orange

Standby

Press

to start

projecting.

Green

Green

Warming up

Wait for a short

time (about 30

seconds).

Projecting

In this mode, you can unplug

the power cable.

Reading the Indicators

In this mode pressing

has

no effect.

(Accessory

Power Cable)

Examples

NEC

Panasonic

SOTEC

HP

TOSHIBA

IBM

SONY

DELL

FUJITSU

Macintosh

Set mirror setting

or display

detection.

Depending on

your OS, you can

select them by

pressing .

Turning on and Projecting

• When using the "Direct

Power On" feature, the

power turns on when the

power cable is connected.

• When using above an

altitude of about 1500 m,

make sure you set the “High

Altitude Mode” to “On”.

User’s Guide "Extended

Menu"

● No image is projected ●

■ For notebooks and computers with liquid

crystal displays

Change the computer’s

output source. Hold

down the

key and

press the appropriate

key (the one usually

labelled

/ ). After

changing the setting,

wait a few seconds for

projection to start.

Computer’s "User’s

Guide"

* If the image is not

projected, press

.

■ For video equipment

Start playback then

press

.

● Adjusting Position and Focus ●

(Setting up for the first time or after moving)

■ Raising the Projection Position (Adjusting the front foot)

When moving the projector, make sure

the front foot is retracted.

You can adjust the front foot to raise the

projection angle up to a maximum of 10°.

Correcting Keystone Distortion

You can adjust the vertical tilt to a maximum of

about 30°*.

* The greater the angle of tilt, the harder the

image is to focus. Setup the projector at a lower

angle of tilt.

• When the "Auto Keystone" function

is turned "Off" in the configuration

menu, automatic keystone

correction is not performed.

(EMP-82/62 only)

• You can also make keystone

corrections from the configuration

menu.

User’s Guide "Settings Menu"

• Hold down

and press for

more than one second to reset the

correction value to the default

setting.

• Adjust the horizontal tilt by turning

the left rear foot.

■ Adjusting Focus

After keystone correction and

sharpness adjustments, the image

may be unfocused.

■ Adjusting Projection Size

● Turning the Projector off ●

Turn off all connected equipment.

Press twice on the remote

control or control panel.

After the confirmation buzzer beeps

twice, unplug the power cable.

Electricity is consumed if only the projector's

power is turned off.

Attach the lens cover.

Foot Adjust

Lever

1 2 3 4 5 6 7 8 9 10 ... 84 85

Comments to this Manuals

No comments