Epson Stylus Color 800N Setup Guide download pdf (Page 17)

Setup Guide

6. Click

Add at the bottom of the dialog box to assign a print

queue to your print server.

The Add Queue dialog box appears:

7. For Print Server mode, select the file server where the print

queue will reside, then select a print queue from the list.

You can create a new queue by entering its name in the

Queue box. Then continue with step 8.

For Auto, assign the same print queues to the printer that

are assigned to the NetWare print server. Make any

additional configuration changes for either Print Server

mode or Remote Printer mode. Then click

Save to save

your settings.

8. Select a priority level for the queue in the Priority box. You

can set a level from 1 to 10, with 1 having the highest

priority.

9. Click

. The NetWare Config dialog box appears again.

10. Repeat steps 6 through 8 if you want to add more print

queues to the print server. Click Save in the NetWare

Config dialog box to save your settings.

After you configure your printer, you need to install EPSON

Status Monitor 2. See page 24 for instructions.

This list indicates

which queues are

available on this

NetWare file server.

Caution:

Once you make changes

to the Ethernet card,

wait for at least five

minutes before turning

off or restarting your

printer.

QuikSet2.fm Page 14 Wednesday, October 15, 1997 3:49 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Epson Stylus Color 800N Setup Guide Page 17