Epson Stylus Pro Original User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Now take the bridge chip and gently push it down on top of
the original chip. The bridge chip will snap into place flush with
the top surface of the cartridge, as in this picture. The bridge
chip has spring loaded pins that line up with the gold contacts
on the original chip below. Repeat this process of removing
original chips and installing them beneath the bridge chips for
on any of the other colors you are going to install at this time.
STEP 2 FILLING THE CARTRIDGES WITH INK
Filling the refillable cartridges is very simple, and is done by injecting ink through the ink fill hole on each
cartridge using syringes with needles fitted that are supplied with the kit. The first time you fill a cartridge,
there are two additional steps that need to be performed before installing it in the printer (see step 3).
If you have purchased the refillable cartridges for use as cleaning cartridges, then you would simply fill them
all with Ink2image Dead Head cleaning fluid instead of ink following the instructions below.
Before filling a cartridge, make sure that the cartridge has an
orange plug fitted over the air port. This is very important as it
will stop any ink from getting into the air pressurization system
on the printer. You should always fit the orange plug over the
air port every time you remove a cartridge from the printer for
refilling.
Place the cartridge on some paper towel with the ink fill hole
upwards as in this picture, and remove the rubber bung from
the ink fill hole. Using a clean syringe with needle fitted, draw
up a syringe full of ink from the correct color ink bottle. Double
check that you are using the correct color ink corresponding to
the color of the cartridge filling the wrong color ink into a
cartridge will mean that the cartridge has to be replaced.
Gently inject the ink into the cartridge until the syringe is
empty, as in this picture.
Page view 3
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments