Epson Stylus Pro XL Service Manual download pdf (Page 39)

4.1.5 Black - Color Head Vertical Adjustment

This adjustment calibrates the vertical position between the black head and the color head. Align the top

nozzles (both nozzle # 1 on the black head and nozzle # 1 on the color head). You can make this adjustment

by using only the linear spacers for the black head. This adjustment is required when the black head or the

color head is replaced or disassembled. The following figure illustrates this adjustment.

1. Connect the PC to the target printer using a parallel interface cable and turn the printer on.

2. Load BASIC on the PC, and run the program. You see the following destination select menu.

***** Customer *****

1. EAI, EAI (Latin America), EAL, ESP

2. EDG, EUL, EFS, EIS, EIB, EUL (Northern Europe), EUL (Middle East), EHK

4. JAPAN

7. END

Select Menu ?

3. Input the number for the destination. Then the main menu appears, as shown below.

If you enter an incorrect number as the destination selection, printer functions are not

guaranteed.

STYLUS Pro XL+ Program : Rev. X

customer :

1. Head VH input

2. Ink consumption counter reset

3. Head angular & linear adjustment

4. Head position check

5. BK. YMC head gap adjustment (head gap center )

6. Bi-D adjustment (Bi-d center )

7. Head VH indication

Magenta

Cyan

Yellow

#16

Color Head

Vertical Position

#1#2

#61

#62

#63

#64

Black Head

Carriage Unit

Adjust

Vertical Position

Figure 4-13. Black - Color Head Vertical Adjustment

Adjustment Stylus Pro XL+ Service Manual

4-12 Rev.A

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 58 59

Comments to this Manuals

No comments

Epson Stylus Pro XL Service Manual Page 39

Comments to this Manuals

Related products and manuals for Print & Scan Epson Stylus Pro XL