Epson 7500 User Manual download pdf (Page 48)

Saving Your Settings and Exiting SETUP

When you leave the SETUP program, you can choose to either

save the settings you have changed or exit the program without

saving any changes.

Follow these steps:

Press

(w].

You see the following prompt:

PRESS F5 TO SAVE AND EXIT

PRESS F1 TO EXIT W/O SAVE

If you want to save your changes,

ress

(7).

If you don’t

want to save your changes, press

Either way, the

system reboots.

If you have just run SETUP for the first time, see “Post-SETUP

Procedures,” below.

Note

You may see an error message and a prompt to run SETUP

when your computer is rebooting if it detects a problem in

your SETUP configuration. If so, follow the instructions on

the screen to run SETUP and correct the problem.

You may also see an error message when your computer is

rebooting if you have not installed your operating system on

the hard disk and you have not inserted a system diskette in

drive A. If you receive this error message, follow the

instructions in your operating system manuals to install the

software on your computer.

2-22

Running the SETUP Program

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 57 58

No comments

Epson 7500 User Manual Page 48