Epson 8100i User Manual download pdf (Page 111)

Notices

105

Remote Control Information

You can operate the projector by remote control via a line-of-sight

infrared (IR) receiver at the front and rear of the projector. The

projector may not respond to remote control commands under the

following conditions:

■

There is an object between the remote control IR emitter and the

IR receiver on the projector.

■

Ambient light is too bright.

■

Certain types of fluorescent lighting are used.

■

A strong light source shines into the IR receiver.

■

Other equipment that emits infrared energy, such as a radiant

room heater, is in the room.

These conditions commonly cause problems for most

infrared-controlled equipment. Try the following:

■

The remote control batteries may be low on power; replace them.

■

Dim the ambient lighting and/or turn off any fluorescent lights.

■

Close any window coverings and/or move the projector out of

direct sunlight.

■

Turn off other equipment that emits infrared energy.

If the remote control still does not work properly, remember you can

always control your computer-based presentation directly from the

computer, even in an environment containing one of the conditions

listed above.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 119 120

No comments

Epson 8100i User Manual Page 111