Epson PowerLite 570 User Manual download pdf

INSTALLATION

HANDBOOK

Remote Control Info

Epson PowerLite 570 / 575W / 580 / 585W

Remote Control Operation

The remote control lets you control the projector from almost anywhere in the room, up to 19.7 feet (6 m)

away. You can point it at the screen or board, or the front or back of the projector.

Make sure that you aim the remote control at the projector's receivers within the angles listed here.

1 19.7 feet (6 m)

2 ± 30º

3 ± 55º

4 ± 60º

5 ± 75º

6 ± 15º

Note: Avoid using the remote control in conditions with bright fluorescent lights or in direct sunlight, or

the projector may not respond to commands. If you will not use the remote control for a long time,

remove the batteries.

Using the Remote Control as a Wireless Mouse

1. Connect the projector to a computer using the projector's USB-B, Computer, or HDMI port to

display video.

2. If you connected your computer to the Computer or HDMI port, also connect a USB cable to the

projector's USB-B port and to a USB port on your computer (for wireless mouse support).

3. Start your presentation.

You can use the projector's remote control as a wireless mouse so you can control projection at a

distance from the computer.

1 2 3 4 5

INSTALLATION 1

Summary of Contents

Page 1 - INSTALLATION

INSTALLATIONHANDBOOKRemote Control Info Epson PowerLite 570 / 575W / 580 / 585W1Remote Control OperationThe remote control lets you control the projec

Page 2

INSTALLATIONHANDBOOKRemote Control Info Epson PowerLite 570 / 575W / 580 / 585W24. Use the following buttons on the remote control to control your pre

Page 3

INSTALLATIONHANDBOOKRemote Control Info Epson PowerLite 570 / 575W / 580 / 585W3Selecting an Image SourceIf you connected multiple image sources to th

Page 4

INSTALLATIONHANDBOOKRemote Control Info Epson PowerLite 570 / 575W / 580 / 585W4Projection ModesDepending on how you positioned the projector, you may

Page 5

Changing the Projection Mode Using the MenusYou can change the projection mode to flip the image over top-to-bottom and/or left-to-right using theproj