Epson Apex+ User Manual download pdf (Page 126)

As each track is checked, the current cylinder is displayed. The

cylinder number counts down to zero as the disk is checked.

When the analysis is complete, the program displays a summary

of the status of the disk. This summary lists these counts:

Flagged bad tracks

Tracks with read, verify errors

Good tracks.

If no errors occur, you see this message:

No read,

verify error was detected.

If errors are found, the program displays a table of the tracks that

produced errors.

After the status reports, you see this message:

Press ENTER to return to the menu.

Check the information displayed, then press Enter.

Using FDISK

FDISK partitions a hard disk so it can run the operating system

you want to use. Follow these steps to partition your hard disk

for MS-DOS:

If you have not already done so, insert your MS-DOS

system diskette into drive A and press Enter. The MS-DOS

command prompt displays:

At the MS-DOS command prompt, type FDISK and press

Enter. The screen displays the FDISK Options menu.

Preparing a Hard Disk For Use B-11

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 157 158

No comments

Epson Apex+ User Manual Page 126