Epson LX-300+ Specifications Page 1

3ULQWHUý6SHFLILFDWLRQVýPrintingPrinting method: 9-pin dot matrixPrint speed:3ULQWLQJýPR GH &KDUDFWHUýVL]HV 0D[LPXPýSULQWLQJýVSHHG'UDIW ìíýFSL

6. Slide the left edge guide to the center until it stops at theguide mark. Then slide the right edge guide to theopposite guide mark.7. Turn on the

5. Insert the paper into the paper slot as shown below andpull it up. Use the scale on the printer as a guide. Positionthe paper using the scale on th

5. Turn the ribbon-tightening knob in the direction of thearrow to remove any slack in the ribbon.6. Insert the ribbon cartridge into the printer as s

Labels:Width 102 to 254 mm (4 to 10 inches) width forbacking sheet63.5 × 23.8 mm (2.50 × 0.94 inches)minimum for a labelThickness 0.07 to 0.09 mm (0.0

Rated current: 1.0 APowerconsumption:Approx. 30 W (during self-test printing indraft mode at 10 cpi)EnvironmentalTemperature: Operation: 5 to 35° C (4

LF/FF buttonPress this button briefly to feed the paper forward one line.Hold this button down to eject a single sheet or to advancecontinuous paper t

Auto line feedWhen the auto line feed feature is on, each carriage return(CR) code is accompanied by a line feed (LF) code. If yourprinted text is une

7. When the control panel lights match your desired setting,press PAUSE.'HIDXOWðVHWWLQJVýPHQX 6HWWLQJV ìýýýýëýýýý3$86(ý&KDUDFWHUVSDFLQJìíýFSL

ZWarning: Never move the print head while the printer is turned on; thiscan damage the printer. Also, if you have just used the printer,let the print

2. While holding down the LF/FF button, turn on the printer.The PAUSE light flashes.3. Slide the left edge guide until it locks in place at the guide

3ULQWLQJýRQý&RQWLQXRXVý3DSHUýYour printer can handle continuous paper with a width of101 mm (4.0 inches) to 254 mm (10.0 inches). Depending onwher