Epson 425Wi Installation Guide download pdf (Page 33)

English

12. Attach the arm cover

Secure the arm cover with a hexagonal wrench (M4) and an M4 × 12 mm hexagon socket head cap bolt.

13. Turn on the projector and check the screen

1. Plug in and turn on the projector.

2. Hold down the A/V Mute button on the remote control for five seconds to flip the image

top-to-bottom.

3. Loosen the screws on the adjustment unit (A, B, C, and D) as shown below to adjust the screen

position.

4. Adjust the vertical angle of the arm using screw (E) on the bottom of the arm plate. The arm rises

when you tighten the screw, and lowers when you loosen it.

M4 × 12 mm hexagon

socket head cap bolt

Arm cover

Arm plate

A: Vertical tilt adjustment: 0 to -9.5°

B: Horizontal roll adjustment: 0 to ± 5°

C: Horizontal rotation adjustment: 0 to ± 5°

D: Horizontal slide adjustment:

0 to ± 1.8 inches (0 to ± 45 mm)

E: Vertical angle adjustment screw:

0 to 5.3 inches (0 to 134 mm) (arm length minimum)

0 to 9.1 inches (0 to 230 mm) (arm length maximum)

Adjustment unit

Installation.book Page 33 Tues day, October 30, 2012 5:53 PM

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 71 72

No comments

Epson 425Wi Installation Guide Page 33