Epson LX-90 User Manual download pdf (Page 8)

Chapter 1

Installation and Operation

After you have set up your printer and loaded the paper (following

the directions in the LX-90 User’s Manual), you are ready to plug in

your Printer Interface Cartridge (PIP™) and begin printing.

Inserting the Printer Interface Cartridge

Inserting the PIC is easy. The cartridge slides into the rectangular

opening, as shown in the LX-90 manual. Be sure the printer is OFF

when you insert the PIC. Once the PIC is installed, you are ready to

test your printer.

Printing the Test Patterns

It’s time to see the LX-90 in action. You’ll start with a test pattern.

Don’t connect the printer to your computer yet-just follow these

steps:

1. Make sure that your printer has paper in it and that the power

switch (on the right side of the printer) is off.

2. Press the LF button on the control panel, and at the same time,

turn the printer on with the power switch.

The LX-90 begins printing letters, numbers, and symbols in the

draft mode. It won’t stop until you turn it off or until it gets near the

end of the paper.

To see the same test in the NLQ (Near Letter Quality) mode, turn

the printer on while pressing the FF button. Figure l-1 shows what

both test patterns look like.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 99 100

No comments

Epson LX-90 User Manual Page 8