Epson ACULASER M8000 User Manual download pdf (Page 195)

Cause What to do

The size of loaded paper differs from the control panel

or printer driver settings.

Make sure that the correct paper size and paper source are set in

the control panel or printer driver.

Too many sheets may be loaded in the MP tray or paper

cassettes.

Make sure that you have not tried to load too many sheets of

paper. For the maximum paper capacity for each paper source,

see “General” on page 231.

If paper does not feed from the optional paper cassette

unit, the unit may not be installed properly.

For instructions on installing the unit, see “Optional Paper

Cassette Unit” on page 108.

The pickup roller is dirty. Clean up the pickup roller. For instructions, see “Cleaning the

pickup roller” on page 149.

The optional paper cassette may not be installed

properly.

See “Optional Paper Cassette Unit” on page 108 for instructions

on installing an optional paper cassette unit.

Paper cannot be output to the Stacker

Cause What to do

The Stacker is not installed correctly. Print a configuration status sheet to see if the Stacker is installed

correctly. See “Printing a Configuration Status Sheet” on page

184.

If the Stacker is not installed correctly, turn off the printer and

reinstall the Stacker properly.

Problems Using Options

To confirm your options are installed correctly, print a configuration status sheet. See “Printing a

Configuration Status Sheet” on page 184 for details.

The message Invalid AUX I/F Card appears on the LCD panel

Cause What to do

The printer cannot recognize the installed optional

interface card.

Turn off the printer, then remove the card. Make sure the interface

card is of a supported model.

EPSON AcuLaser M8000 Series User's Guide

Troubleshooting 195

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 247 248

No comments

Epson ACULASER M8000 User Manual Page 195