Epson EPL-N2700 Specifications Page 113

  • Download
  • Add to my manuals
  • Print
  • Page
    / 165
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 112
EPSON EPL-N2700 Rev. A
Chapter 4 Disassembly/Assembly 113
4.2.21 Fusing Section
4.2.21.1 Fuser Unit Removal
1. Open the vertical transport door. (See Section 4.2.4.)
2. Remove the Front Cover. (See Section 4.2.17.)
3. Disconnect the heater lamp harness from the connector (heater
power source) on the front and release the harness from the cable
clamp and edge cover which are on the printer frame.
Figure 4-36. Connector (Front) Removal
4. Open the Fuser Unit and disconnect the connectors at the rear side.
5. Remove two screw (3504 and 4011) securing the Fuser Unit to the
printer main body.
Figure 4-37. Fuser Unit Removal
CAUTION
The Fuser Unit is hot right after printing. Therefore, be
careful not to get burnt when handling the Fuser Unit.
If you have replaced the Fusing Unit, perform “Fuser
Counter Clear” in the maintenance mode. (See
Chapter 1 / Section 1.4.5.)
Page view 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 164 165

Comments to this Manuals

No comments