Epson Stylus CX8400 Service Manual Page 103
- Page / 159
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 103
Confidential
4. Remove the screw (x1) that secures the Main Board, and remove the Main
Board.
Figure 4-19. Removing the Main Board (2)
4.4.2 Panel Unit/LCD Unit
Parts/Components need to be removed in advance: None
Removal procedure
1. Open the Scanner Unit
2. Raise the LCD Unit.
3. Lifting the front of the Panel Unit, and release the tabs of it.
4. Slide the Panel Unit in the direction of the arrow, and release the hooks of it
from the Upper Housing.
Figure 4-20. Removing the Panel Unit and LCD Unit (1)
When installing the Main Board,
pay attention to the following
instructions.
Match the positioning holes of the Upper Shield Plate with
the guide pins of the Main Board as shown in
Figure 4-19.
Match the positioning hole of the Main Board with the guide
pin of the MB Lower Shield Plate as shown in
Figure 4-18.
When installing the MB Lower Shield Plate, make sure that
the Upper Shield Plate is set over the MB Lower Shield Plate
as shown in
Figure 4-18.
A D J U S T M E N T
R E Q U I R E D
Whenever the Main Board is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 “ ADJUSTMENT” (p.141)
C.B.S. 3x10, F/Zn-3C (4±0.5kgfcm)
Positioning Hole and Guide Pin
Upper Shield Plate
Main Board
C H E C K
P O I N T
The disassembling/assembling procedures differ depending on the
models. As for CX7300/TX200 series, see
4.7.1 Panel Unit
(CX7300/TX200 series) (p139).
C A U T I O N
Do not lift the Panel Unit too fast, since the Panel FFC is connected
to it.
Panel Unit
LCD Unit
Hook
Tab
Back side
Upper
Housing
- SERVICE MANUAL 1
- PRECAUTIONS 3
- About This Manual 4
- Revision Status 5
- Contents 6
- Chapter 6 MAINTENANCE 7
- Chapter 7 APPENDIX 7
- Chapter 5 ADJUSTMENT 7
- PRODUCT DESCRIPTION 8
- 1.1 Features 9
- 1.2 Printing Specifications 10
- (H x V dpi) 11
- 1.2.4 Supported Paper 13
- 1.2.5 Printing Area 15
- 1.3 Scanner Specifications 15
- 1.3.1 Scanning Range 15
- (1 msec or less) 16
- (2 msec or less) 16
- 1.5 Interface 17
- 1.5.2 Memory Card Slots 18
- 1.6 Control Panel 19
- 1.7.1.4 Copy Speed 30
- 1.7.2.7 Print Layout 34
- <Borderless> 35
- <With Border> 35
- Paper top edge 35
- (USB Direct Print/PictBridge) 36
- USB Direct Print 37
- PictBridge 37
- 1.7.5 Setup Mode 39
- 1.7.5.8 Head Alignment 40
- OPERATING PRINCIPLES 41
- 2.1 Overview 42
- 2.1.2 Motors & Sensors 43
- 2.1.3 Printhead 44
- 2.1.3.1 Printing Process 45
- 2.1.3.2 Printing Method 45
- Carriage Unit 46
- Main Frame 46
- Timing Belt 46
- 2.1.5.2 Paper Feed Mechanism 51
- 2.1.6 Ink System Mechanism 52
- 2.1.6.3 Wiping Mechanism 53
- 2.1.6.4 Pump Unit Mechanism 54
- 2.1.7 Ink Sequence 55
- 2.2 Scanner Mechanism 56
- TROUBLESHOOTING 58
- W A R N I N G 59
- 3.2 Troubleshooting 60
- Scanner Carriage FFC 66
- Scanner Carriage Unit 66
- Compression Spring 2.36 68
- Change Lever 68
- Upper Paper Guide Unit 68
- Slit of the CR Encoder Board 69
- CR Scale 69
- CR Encoder BoardEncoder FFC 69
- PF Scale PF Encoder Sensor 70
- PE Sensor 70
- Connector Cable 70
- Paper Back Lever 71
- Extension Spring 6.4 71
- Extension Spring Retard 71
- Backside of ASF Unit 71
- Star Wheel Holder Assy 72
- Star Wheel Holders 72
- EJ Roller Unit 72
- Document Glass 78
- Backside of ASF 79
- Extension Spring 6.45 79
- Panel FFC 80
- PS Board 81
- Power Unit Cable 81
- PS Board Unit 81
- Seal rubber part 85
- Compression 85
- Spring 1.67 85
- CR movement 87
- PF Roller Unit 87
- LD Roller 88
- Front Paper Guide Unit 88
- Porous Pad Front Paper Guide 88
- Star Wheels 89
- DISASSEMBLY/ASSEMBLY 90
- 4.1.2 Tools 92
- 4.1.3 Work Completion Check 92
- Panel Unit 94
- LCD Unit 94
- 4.2 Disassembly Procedures 95
- Paper Support Assy 96
- Guide Pins 96
- Stacker Assy 96
- Document Cover 97
- ASF Cover 97
- 4.3.4 Scanner Unit/Hinge 98
- Confidential 100
- 4.4.1 Main Board Unit 101
- 4.4.2 Panel Unit/LCD Unit 103
- 4.4.3 Power Supply Unit 105
- 4.5.1 Printhead 107
- 4.5.2 CR Scale 109
- 4.5.3 Hopper 110
- 4.5.5 Left Frame 113
- 4.5.7 Star Wheel Holder Assy 116
- 4.5.8 EJ Roller 116
- 4.5.9 PF Encoder Sensor 117
- 4.5.10 PF Scale 118
- 4.5.11 PF Motor 119
- 4.5.12 CR Motor 120
- 4.5.13 Main Frame Assy 122
- 4.5.14 CR Unit 124
- 4.5.15 Upper Paper Guide 126
- 4.5.16 ASF Unit 126
- 4.5.17 Ink System Unit 128
- Waste Ink Tube 130
- Tube Stopper 130
- 4.5.18 Front Paper Guide 131
- 4.5.19 PF Roller 132
- 4.5.20 Waste Ink Pads 133
- 4.6.2 Scanner Carriage Unit 135
- Scanner Timing Belt 137
- Torsion Spring 137
- Scanner CR Holder 137
- 4.6.3 Scanner Motor Unit 138
- Stylus CX7300/TX200 series 139
- ADJUSTMENT 141
- C H E C K 142
- P O I N T 142
- 5.1.2 Required Adjustments 144
- 5.2.1 TOP Margin Adjustment 146
- 5.2.4 Bi-D Adjustment 148
- 5.2.5 PF Adjustment 148
- 34 56 782 149
- MAINTENANCE 151
- C A U T I O N 152
- Driven Pulley 153
- MAINTENANCE Overview 154 154
- MAINTENANCE Overview 155 155
- MAINTENANCE Overview 156 156
- MAINTENANCE Overview 157 157
- APPENDIX 158
Related products and manuals for Print & Scan Epson Stylus CX8400
Print & Scan Epson A251E User's Guide
(58 pages)
(58 pages)
Print & Scan Epson Stylus 1500 Specifications
(119 pages)
(119 pages)
Print & Scan Epson NPD4736-00 EN User Manual
(110 pages)
Print & Scan Epson LQ-570+ Specifications
(12 pages)
(12 pages)
Print & Scan Epson Stylus C87 Specifications
(49 pages)
(49 pages)
Print & Scan Epson 600Q User's Guide
(12 pages)
(12 pages)
Print & Scan Epson SC-T3000 User's Guide
(251 pages)
(251 pages)
Print & Scan Epson LQ LQ-870 User Manual
(5 pages)
(5 pages)
Print & Scan Epson Stylus TX210 User Manual
(52 pages)
(52 pages)
Print & Scan Epson Stylus Pro XL User Manual
(18 pages)
(18 pages)
© 2020, manymanuals.com. All rights reserved. | 1.114 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals