EPSON Stylus Scan 2000
8 -
EPSON Stylus Scan 2000
9/99
Replacing an Ink Cartridge
When the
B black or
A color ink out light flashes, the
indicated cartridge is low on ink. This is a good time to make
sure you have a new cartridge. When the light stays on, the
cartridge is empty and you need to replace it.
Use these EPSON ink cartridges within six months of
installing them and before the expiration date on the package:
Black ink cartridge: S020189
Color ink cartridge: S020191
Caution:
To ensure good results, use genuine EPSON cartridges and do not
refill them. Other products may cause damage to your printer not
covered by EPSON’s warranty.
If you need to replace an ink cartridge before
beforebefore
before the lights flash
(because the ink is too old, for example) follow the
instructions in “Replacing an Outdated Ink Cartridge” on
page 9.
Replacing the Color Ink Cartridge
You can replace a cartridge when the
A color ink out light is
either flashing or on.
1. Remove the new ink cartridge from its packaging.
2. Remove only
onlyonly
only the yellow part of the tape seal on top as
shown below.
Caution:
You must remove the yellow tape from the top of the cartridge or
you will permanently damage it. Don’t pull off the blue portion or
remove the clear seal from the bottom of the cartridge; ink will
leak out.
To avoid damaging the printer, never move the print head by hand.
3. Lower the output tray, then open the front cover.
4. Press the
R cleaning button and hold it for about three
seconds until the print head moves left and the
Ppower
light begins flashing.
5. Pull up the ink cartridge clamp. The cartridge rises up from
its holder.
Caution:
Don’t open the clamp or remove a cartridge except to replace it
with a new one. Once you remove a cartridge, you can’t reuse it,
even if it contains ink.
6. Lift the cartridge out of the printer and dispose of it
carefully.
WARNING:
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets into your eyes, flush them immediately with
water.
7. Lower the new ink
cartridge into its holder
with the label facing up
and toward the back of
the printer.
8. Press down the ink
cartridge clamp until it
locks in place.
9. Press the
R cleaning button and release it quickly.
The printer moves the print head and begins charging the
ink delivery system. (Even if you don’t press the button, ink
charging begins 60 seconds after you close the clamp.)
The
P power light flashes, and the printer makes various
sounds. Charging takes about 60 seconds. When it’s
finished, the
P power light stops flashing and stays on.
Caution:
Never turn off the printer while the
P
power light is flashing,
unless the printer hasn’t moved or made any noise for more than
5 minutes.
10. Close the front cover.
black cartridge
color cartridge
(26 pages)
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals