Epson FX-870/1170 User Manual Page 51

  • Download
  • Add to my manuals
  • Print
  • Page
    / 181
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 50
Installation and Setup
The cable configuration for connecting the printer serially to a 25-pin (XT-type) computer
connector is shown in the figure below.
PtiIltff
side
25pin
to
25pin
Serial Cable
Computer
1 FGND,
,l
FGND
:~.-x,xl
5
CTS
4
,5
CTS
6 DSR
4
+6
DSR
Figure 2-2. Serial Cable Configuration to a
25Pin
Computer Connector
-
Checking the Printer with the Computer
The paragraphs below describe ways to check the computer’s connection to the printer. If
you have problems after performing these checks, see Chapter 3,
Troubleshooting.
Parallel Connection to an MS-DOS Computer
Once you have connected the printer to the computer, you can test the connection by send-
ing a print screen to the printer. (At the MS-DOS prompt, type
DIR
and press
Enter.
Then
press
Print Screen
or
Shift+Print Screen.)
If the printer does not respond, try modifying the MS-DOS MODE command. From the
MS-DOS directory, type the following command and press
Enter:
MODE
LPTn,,P
In this command,
n
represents the port you are sending data through (typically
LPTl
or
LPTB)
and P specifies unlimited retries for time-out errors. The computer will respond with
the message:
Resident
portion
of
MODE
loaded
Infinite
retry
on
parallel
printer
time-out
Epson
FX-870/1170
2-3
Page view 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 180 181

Comments to this Manuals

No comments