Epson Stylus NX100 User Manual download pdf (Page 29)

Problems and Solutions 29

Problems and Solutions

Check the solutions below if you’re having trouble using your NX100 Series.

Printing and Copying Problems

■ Make sure your original is positioned in the front right corner of the glass. If

the edges are cropped, move your original away from the edges slightly.

■ Make sure your paper is loaded short edge first and is positioned against the

right side with the edge guide against its left side. Don’t load paper above the

arrow mark inside the edge guide.

■ Make sure the paper size settings are correct for the paper you loaded.

B ink light flashing One or more cartridges have low ink. You can continue

printing until a cartridge needs replacement. Check the

cartridge status to determine which cartridges are

affected (see page 22).

B ink light on One or more ink cartridges are expended, incorrectly

installed, or cannot be used with the printer. If an ink

cartridge is likely to be expended, you must replace the

cartridge to be able to print. If you just replaced a

cartridge and the light is still on, the cartridge is not

installed correctly. Press the y Stop button to move

the cartridges to the replacement position. Press down

on all the installed cartridges, then press the y Stop

button to continue.

All lights are on Parts inside the NX100 Series are at the end of their

service life. Contact Epson for help (see page 31).

All lights are flashing There is a problem with the NX100 Series. Turn it off,

wait a few moments, and turn it back on again. If the

error is not resolved, contact Epson for help (see

page 31).

Light status Problem and Solution

nx_tx_100_qg.book Page 29 Wednesday, May 21, 2008 3:20 PM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

No comments

Epson Stylus NX100 User Manual Page 29