Epson 10+ User Manual download pdf (Page 4)

EPSON PowerLite Home 10 Projector

4 - EPSON PowerLite Home 10 Projector 7/03

Turning the Projector On and Off

Once you’ve connected the projector to your computer or other

equipment, follow these instructions to turn it on and display

an image:

1. Make sure the power is turned off for the projector and any

sources connected to it.

2. Remove the lens cover.

3. Connect one end of the power cord to the projector and plug

the other end into a grounded electrical outlet.

The P

Power light on the projector turns orange, indicating

that the projector is receiving power, but is not yet turned

on.

Note: The projector will not respond to any buttons on the

control panel or remote control while the power light is

flashing orange.

4. If you are connecting to video equipment, turn it on now. (If

you are connecting to a computer, don’t turn it on yet.)

5. Press the P

Power button on the remote control or the top

of the projector to turn on the projector.

You hear a beep, the P

Power light flashes green as the

projector warms up, and the projection lamp comes on in

about 45 seconds.

6. If you are using a computer, turn it on now.

The projector automatically detects the video source and begins

projecting.

If you don’t see a picture, make sure the P power light on the

projector is green and not flashing, and the lens cover is off.

Also, make sure your cable is connected to both the projector

and your video equipment, and the video equipment is on. If

you still don’t see a picture, see the suggestions in the

Troubleshooting section on page 6.

Turning Off the Projector

When you’re ready to shut down the projector, follow these

steps:

1. Turn off your video equipment first. (If you’re connecting to

a computer, leave the computer on.)

2. Press the P

Power button on the projector or remote

control.

3. When you see the confirmation message, press the P

Power

button again to turn the projector off. (If you don’t want to

turn it off, press any other button or ignore the message. It

disappears in about 7 seconds.)

The lamp is turned off and the P

Power light flashes orange

as the projector cools down. When the projector has cooled,

the P

Power light stays orange and the exhaust fan shuts

off.

Note: If you want to turn the projector on again, wait until

the orange light stops flashing. Then press the P

Power

button.

4. Unplug the power cord from the electrical outlet.

Caution: Never disconnect the power cord while the

P power light is green or flashing orange. You may damage

the projector.

5. Replace the lens cover and retract the projector’s adjustable

feet.

6. Store the remote control in its holder on the back of the

projector. (Part of the remote control will stick out when it’s

fully inserted.)

Adjusting the Image

1. To raise the picture, turn the projector’s front feet.

Orange

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Epson 10+ User Manual Page 4

Comments to this Manuals

Related products and manuals for Projectors Epson 10+