Epson 737C User Manual download pdf (Page 7)

Epson PowerLite 737c Projector

2/05 Epson PowerLite 737c Projector - 7

Using Direct Power On

The Direct Power On function enables faster setup. The

projector will start up automatically when you plug it in; you

won’t have to press the P

Power button.

Follow these steps to enable Direct Power On:

1. Press the

Menu button on the remote control and select the

Extended menu.

2. Choose

Operation and press Enter.

3. Choose

Direct Power On and press Enter.

4. Highlight

ON and press Enter.

5. Press

Esc or Menu to exit.

Note:

When Direct Power On is enabled, shut down the projector as you

normally would. Follow the instructions in the next section. (The

projector will start automatically when power is restored after a

power failure if it is plugged in.)

Shutting Down the Projector

When you’ve finished using the projector, follow the

recommended procedure to shut it down. This extends the

lamp life and protects the projector from possible overheating.

1. Turn off any equipment plugged into the projector.

2. To turn off the projector, press the P

Power button on the

projector or remote control. You see a confirmation message.

(If you don’t want to turn it off, press any other button.)

3. Press the P

Power button again. The P Power light flashes

orange as the projector cools down. When the projector

beeps twice, it’s safe to unplug it.

To turn the projector on again, wait until the P

Power light

stops flashing. Then press the P

Power button.

4. Press up on the blue foot release lever and lower the

projector to retract the front adjustable foot, as shown.

5. Replace the lens cap and unplug the power cord.

Caution

To avoid damaging the projector or lamp, never unplug the

power cord when the P

Power light is green or flashing orange.

Using the Remote Control

Before using the remote control, insert the two AAA alkaline

batteries, as described on page 8.

When using the remote control, stand within 20 feet of the

projector. Point the remote control either at the projector or at

the screen (the projector’s front sensor can detect signals

bounced off the screen). Press the button for the function you

want to use.

Turning Off the Picture and Sound

You can use the A/V Mute button on the remote control to turn

off the image and sound. This is useful if you want to

temporarily redirect your audience’s attention.

❏ To turn off the picture and sound, press the

A/V Mute

button. The screen turns blue.

❏ To turn the image and sound back on, press the

A/V Mute

button again.

You can create an image, such as a company logo or a picture, to

display on the screen whenever you press the

A/V Mute button.

See the User’s Guide for more information.

Stopping Action

Press the Freeze button to stop the action in your video or

computer image and keep the current image on the screen. The

sound will continue.

To restart the action, press the

Freeze button again or

press

Esc.

Zooming Your Image

Follow these steps to zoom in on a portion of the image:

1. Press the

E-Zoom button on the remote control. You see

a crosshair indicating the center of the zoom-in area.

2. Use the pointer button to position the crosshair in the

area you want to enlarge.

3. Continue pressing the

E-Zoom button to enlarge the

selected area up to 4 times.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Comments to this Manuals

No comments

Epson 737C User Manual Page 7

Comments to this Manuals

Related products and manuals for Projectors Epson 737C