Epson EB-X11H User's Guide download pdf (Page 82)

Warning

• When replacing the lamp because it has stopped illuminating, there is a

possibility that the lamp may be broken. If replacing the lamp of a projector

which has been installed on the ceiling, you should always assume that the

lamp is cracked, and you should stand to the side of the lamp cover, not

underneath it. Remove the lamp cover gently. Be careful when removing the

lamp cover as shards of glass may fall out and could cause an injury. If any

shards of glass get into your eyes or mouth, contact your local physician

immediately.

• Never disassemble or remodel the lamp. If a modified or disassembled lamp

is installed in the projector and used, it could cause a fire, electric shock, or

an accident.

Caution

Wait until the lamp has cooled down sufficiently before removing the lamp

cover. If the lamp is still hot, burns or other injuries may result. It takes about

one hour after the power has been turned off for the lamp to be cool enough.

After you turn off the projector's power and the confirmation

buzzer beeps twice, disconnect the power cord.

Wait until the lamp has sufficiently cooled down, and then remove

the lamp cover at the top of the projector.

Loosen the Lamp cover fixing screw with the screwdriver supplied

with the new lamp unit or a cross-head screwdriver. Then slide the

lamp cover straight forward and lift it to remove.

Loosen the two lamp fixing screws.

Replacing Consumables

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 102 103

No comments

Epson EB-X11H User's Guide Page 82