Epson EMP-S3 Service Manual Page 65

  • Download
  • Add to my manuals
  • Print
  • Page
    / 96
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 64
4-4
EMP-S3
SEIKO EPSON Revision:B
4.1.2 Tools and Equipment
The tools and equipment in the following table will be needed. All are commercially available,
and should be made ready beforehand.
4.1.3 Projector-Specific Service Precautions
Table 4-1. Tools Needed
Name Application
Phillips screwdriver No. 0 Disassembling the Focus ring
Phillips screwdriver No. 2 (20 cm)
Disassembling the outer case and inner
components
Flathead screwdriver
Disassembling the rear foot and the
front foot
Flathead precision screwdriver Removing the front foot
Hexagonal box screwdriver (5 mm) Removing the computer interface
Brush Cleaning away dust
Vacuum cleaner Cleaning away dust
Lens cleaner Cleaning the projection lens
Air blower Cleaning the light valves and fans
Gloves Protection against sharp edges
Antislip and static protection
Grounding strap Anti-static protection
Heat-resistant tape Securing cables
C H E C K
P O I N T
The Optical Engine and Main (MA) Board are paired together as a single service
part. Neither is available separately. For service that requires the replacement of
either the MA Board or the Optical Engine, both components must be replaced
together.
The component parts of the Optical Engine require mechanical installation
positions to be adjusted in relation to each other. In addition, the control circuit
also has its own unique characteristics, such as display signal output drivers, that
differ from projector to projector. There are also unique differences in each
optical system mechanism, such as in the light valves.
In order to obtain the optimum display, it is necessary to eliminate these
differences in electrical and mechanical characteristics as well as to make
mechanical adjustments. The various correction values are set at the time of
shipment from the factory and are stored in ROM on the MA Board.
Always replace the Optical Engine and MA Board together as a matched pair.
Do not disassemble the Optical Engine.
Do not replace the component parts of the Optical Engine with parts from
other Optical Engines.
Page view 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 95 96

Comments to this Manuals

No comments