Epson Expression 1680 User Manual download pdf (Page 34)

2-14

Setting Up the Scanner

R4C6740

Setup Guide Rev. C

SETUP.FM A5 size

10/26/00

Proof Sign-off:

K.Pipa

J.Miyakoshi

K.Norum

3. Connect the other end of the cable to the SCSI port of your

computer or another SCSI device.

Note:

The SCSI port on the Macintosh is the larger port with the SCSI

icon over it.

4. Plug in the power cords of your computer, scanner, and other

external SCSI devices.

When all devices are connected and plugged in, take note of the

information in “Power-on sequence” on page 2-14 and “Power-

off sequence” on page 2-15, then install the scanner software as

described in Chapter 3.

Power-on sequence

Always turn on your scanner or other SCSI devices before turning

on the computer. If your scanner is connected to a daisy chain,

turn on the SCSI device which is connected at the farthest end of

the chain first, then proceed to the second farthest device and so

on before turning on your computer. If you attempt to use a SCSI

device that has been turned on after the computer, it may not work

properly, or the computer may not work properly.

Note:

If the scanner software is not yet installed, a dialog box or message

prompting you to set up the device and install the scanner software may

appear when you turn on the computer when the scanner is on. In this

case, see the scanner software installation instructions in Chapter 3,

“Installing the Software,” to complete the setup procedure.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 123 124

No comments

Epson Expression 1680 User Manual Page 34