9. Open the Device menu and select Quit.
10. Turn off the scanner.
11. Disconnect the computer or device's direct Wi-Fi connection, then connect the computer or device to
the router or access point.
12. Set the connection mode switch on the scanner to Wi-Fi.
13. Turn on the scanner.
When the Status light on the scanner stays on, the connection is established.
14. Set up network scanning on your computer.
Parent topic: Connecting to an Existing Wi-Fi Network
Related tasks
Setting Up Network Scanning
Setting Up Network Scanning
You can set up network scanning using one of these methods:
• through a direct connection to your scanner
• through a connection with the optional Epson Network Interface Unit
Note: Make a note of the IP address or host name of the Network Interface Unit or scanner so you can
enter it in these steps.
1. Do one of the following:
• Manually configure your scanner to connect to your network
• Connect the Epson Network Interface Unit to your scanner and verify they are working properly.
36
Comments to this Manuals