
5-2 BIOS Functions Rev. D
BIOS Setup
The BIOS setup utility is used to configure the systemís operating environment. When setting
up this product for the first time, be sure to run this program. If you change the operating
environment, run this program again.
Operating Procedures
How to use setup
Executing BIOS setup requires a PS/2-compatible keyboard. BIOS setup cannot be run from the
touch panel alone.
Start the BIOS setup utility according to the following procedures:
1. Connect the PS/2 keyboard to the keyboard connector. A USB keyboard can also be used
except when USB Legacy Support is Disabled and USB Controller is Disabled.
2. Turn the power button of the system on to boot.
3. Press Del during the POST process, and the BIOS setup utility will boot.
CAUTION
Do not change the settings of any items other than those specified in this manual.
Do not change the settings of any items for which "Do not change" is specified in
this manual.If an incorrect setting is made, the system may not operate.
How to exit
Enable the Configuration
Follow the steps below to enable the new configuration and exit the BIOS setup utility:
1. Press the F10 key. Or select "Save Changes and Exit" in the Exit menu.
2. "Save configuration changes and exit setup?" is displayed.Select OK and press the Enter key.
The BIOS setup finishes, and the system reboots with the new configuration enabled.
Disable the Configuration
Follow the steps below to discard the new configuration and exit the BIOS setup utility:
1. Press the Esc key. Or select "Discard Changes and Exit" in the Exit menu.
2. Discard Changes and Exit Setup? Setup?"is displayed. Select OK and press the Enter key.
The BIOS setup finishes, and the system reboots with the new configuration discarded.
Comments to this Manuals