Epson EMP-51 User Manual download pdf (Page 69)

Switch off power to the projector and

disconnect the power cord after cool-down

ends.

Cool-down time varies according to external

temperature and other factors.

After the projector has cooled completely,

remove the lamp cover.

• The projector requires approximately 60

minutes to cool completely.

• Press on the 2 catches and pull the cover

out diagonally.

Pull the lamp out.

Use a screwdriver to loosen the two lamp

retaining screws, then grasp the holds and

pull the lamp out.

Install a new lamp.

Align the lamp properly, insert the lamp

until it contacts the rear of the housing, and

use a screwdriver to tighten the two lamp

retaining screws firmly.

Install the lamp cover.

Insert the cover diagonally and press it into

the projector until you hear the catches click

into place.

Check that the catches are securely fastened.

Tip:

After lamp replacement, use the About menu to

reset lamp time to its initial value (See page 50).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 81 82

No comments

Epson EMP-51 User Manual Page 69