Epson EMP-730 User Manual download pdf (Page 37)

* This value applies when the zoom ring is turned to the maximum "T" setting.

If the zoom ring is turned to the "W" setting, the available angle of tilt for

automatic adjustment will become smaller.

Tip :

• Automatic keystone correction is not carried out when the "Rear" or "Ceiling"

commands in the "Advanced" menu are set to "ON".

• If you would like to make further adjustments after automatic keystone correction has

been carried out, you can use the [keystone] button on the projector's control panel.

(p.36)

Procedure

While pressing the two foot adjust

buttons at either side, lift up the front

of the projector so that the front

adjustable feet can extend.

Extend the front adjustable feet until the

desired angle is obtained, and then release the

foot adjust buttons.

To retract the front adjustable feet, gently push

down on the projector while pressing the two

foot adjust buttons.

Tip :

• If the projector is tilted horizontally, turn the bases of the front adjustable feet to adjust

the angle.

• When keystone correction is carried out, the projected image will become smaller.

• If the images become uneven in appearance after keystone correction is carried out,

decrease the sharpness setting. (p.47, 48)

• If automatic keystone correction is not required, set "Auto Keystone" in the "Setting"

menu to "OFF". (p.51)

Foot adjust buttons (side)

Extend Retract

Front adjustable

foot

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 99 100

No comments

Epson EMP-730 User Manual Page 37