Epson Endeavor User's Guide download pdf (Page 39)

Using a

Password

If you set a System Access password when you ran the SETUP

program, you must enter it every time you turn on or reset the

computer. Follow these steps to use your password:

If you do not have a hard disk, insert your system diskette

in drive A.

Turn on or reset the computer. You see the following prompt:

Enter Password:

Type your password. You see an asterisk for each character

you type. Then press

[Enter].

After you type the password correctly and press

[=I,

the

computer loads the operating system and displays the

command prompt.

Note

If you do not know the correct password, see “Password

Problems” in Chapter 6.

Changing or Deleting a Password

To change or delete your password, you must run the SETUP

program and follow the instructions for entering a password in

Chapter 2 of the

Setup Guide.

If you do not know your password, see “Password Problems”

in Chapter 6.

Using Your Computer

1-23

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 196 197

No comments

Epson Endeavor User's Guide Page 39