54
Setting up
The procedure to install the ASF is:
1. Use the printer’s EDS mode to select ASF as “installed”. (For details,
please refer to Chapter 5.)
2. Open the front cover by lifting up the back using the two grips on either
side, then remove the cover by pulling up.
3. Move the printer bail lever toward the front of the printer to open the
paper bail.
Figure 7-2.
Remove the front cover, and move the bail lever toward the front of the printer.
4. Secure the mounting brackets of the Automatic Sheet Feeder onto the
shaft of the platen by lowering it into position as shown in Figure 7-3.
Figure 7-3.
Mount the Automatic Sheet Feeder onto the printer.
Comments to this Manuals