Epson R800 Troubleshooting Guide download pdf (Page 8)

Epson Stylus Photo R800

8 - Epson Stylus Photo R800 1/04

Loading Envelopes

You can load up to 10 envelopes at a time, as described below.

For best results, press each envelope flat before loading it, or

load one envelope at a time.

1. Open the paper support and slide out the support extension

2. Open the output tray and its extensions. Make sure the tray

is in the lower position.

3. Load envelopes short edge first as shown, with the flap side

down and the flap edge facing left.

4. Slide the left edge guide against the envelopes.

5. Choose these settings in your printer software:

❏

Plain Paper as the Type (Windows) or Media Type

(Macintosh) setting

❏ The envelope size as the Size (Windows) or Paper Size

(Macintosh) setting

❏

Landscape as the Orientation setting

If printing is smeared on your envelope or on other thick

paper, select the

Thick paper and envelopes checkbox in

your printer software.

Loading Roll Paper

You can load 4-inch and 8.3-inch wide roll paper for printing

multiple photos or panoramics, with or without borders.

It’s a good idea to check and make sure your ink cartridges are

not low before loading and printing on roll paper. If you need

to replace a cartridge with roll paper loaded, you should

remove the paper or marks may appear in your printout.

1. Turn on the printer and remove any paper loaded in the

sheet feeder at the top of the printer.

2. Open the output tray, but don’t pull out the extension. Also

make sure the tray is in the lower position.

3. Place the roll paper on the holders as shown, then remove

any tape and protective paper from the end of the roll.

4. Make sure the end of the paper is cut straight across, with

90° corners. If the end is cut diagonally, you may have

problems feeding the paper.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Epson R800 Troubleshooting Guide Page 8