78 Technical Manual
Version 5.0.1 Inepro B.V.http://www.inepro.com
A
1) Make sure the USB device does work on another till, if so call the Inepro
Helpdesk, it could be one of these problems:
a) Ensure that the USB controller is “enabled” in the CMOS setup.
b) Check if the 4pin USB cable is properly connected between 9000PB0710
secondary I/O CN9 and mainboard J8.
c) The mainboard or 9000PB0710 secondary I/O board could be defective.
Comments to this Manuals