Epson ActionPrinter 3260 s User's Guide download pdf (Page 42)

Getting the results you expect

When you print on single sheets, you may notice that the

printer prints the first page of your file correctly, but then

prints too low on the next page, or that it prints the last few

lines from one page onto the next. This happens because single

sheet handling differs slightly from continuous paper handling.

It’s easy to adjust the printer so that you get the right results.

Simply change the settings in your software program as

described below.

1. When you install a software program, it normally asks you

what printer you are using. Make sure you choose the

correct printer. See Chapter 1 for instructions.

2. Many programs have an option that you can use to set the

maximum lines per page. If you are using standard

8 1/2

11-inch paper, set the lines per page to 61.

Note:

To find the right lines-per-page setting for paper other than

8 1/2

11, create a test document using your software program.

Set your top and bottom margins to 0 and then create a file of

numbered lines from 1 to 66. When you print your file, notice the

last number printed on the first page. This is your maximum

lines-per-page setting.

3. If your program does not have a lines-per-page setting, try

decreasing the top margin or increasing the bottom margin,

or both, until you get the results you want.

4. You can also try adjusting the form length setting. For a

standard 8 1/2

11-inch page, try setting the form length to

10 inches.

5. Some programs let you indicate whether you are using

single sheets or continuous paper. Make sure you choose

single sheets.

Blackberry REV.D

A5 size Chapter 2

96/04/08 pass 1

2-6

Using the Printer

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

No comments

Epson ActionPrinter 3260 s User's Guide Page 42