Epson T-750 User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
To run the same test in the draft mode, hold down the
LINE FEED
button instead of the
FORM FEED
button while you turn the printer on.
The T-750 cannot print a draft self test, however, if the NLQ DIP switch
is on. Therefore, if the Print Quality line of the self test printout says
NLQ, you cannot print a draft test without changing a DIP switch.
9 Connecting the Printer to Your Computer
Your T-750 printer communicates with your computer through a
Centronics® compatible parallel interface. If your computer uses this
type of interface and you have a suitable cable, you can connect your
computer immediately. (Be sure that your cable is a shielded cable.)
If you do not know what kind of interface your computer requires,
consult its manual. For further information on the standard interface,
see Appendix E.
The parallel interface
Before connecting a parallel interface cable, see that both the printer
and computer are turned off. Then plug the connector into the printer.
Next squeeze the clips gently and click them into place.
Some parallel cables have a ground wire. Connect this wire to the
ground screw on the printer to protect data from interference. Then
plug the other end of the cable into the computer and connect the
ground wire on the computer end of the cable if it has one. Figure 1-13
shows a properly connected parallel cable.
Figure 1-13.
Connecting a parallel cable
Setting Up Your T-750 Printer
1-17
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 155 156

Comments to this Manuals

No comments