Epson BrightLink 480i User's Guide download pdf (Page 70)

Note: If you want to use the Crestron RoomView system when the projector is turned off, you need to

adjust the Standby Setup settings in the Extended menu.

1. Press the Menu button.

2. Select the Network menu and press Enter.

3. Select Network Configuration and press Enter.

5. Set the Crestron RoomView setting to On to allow the projector to be detected.

6. When you finish selecting settings, select Complete and follow the on-screen instructions to save

your settings and exit the menus.

7. Turn off the projector, then turn it on again to enable the setting.

Parent topic: Crestron RoomView Support

Controlling a Networked Projector Using Crestron RoomView

Once you have set up your projector to use Crestron RoomView, you can control and monitor projection

using a compatible web browser.

1. Start your web browser on a computer connected to the network.

2. Type the projector's IP address into the browser's address box and press the computer's Enter key.

You see this screen:

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 258 259

No comments

Epson BrightLink 480i User's Guide Page 70