Epson ELPMBPRG User Manual download pdf (Page 5)

5 of 11

Visit the Peerless Web Site at www.peerless-av.com For Technical Support Contact Peerless Mounts at 1-800-865-2112

ISSUED: 04-01-08 SHEET #: 055-9254-19 02-28-14

Place projector mount assembly (A) on ceiling as a template and mark the center of the two mounting holes. Make

surethatthemountingholesareinthecenterofthewoodjoist.Drilltwo5/32"(4mm)dia.holestoaminimum

depthof2.5"(64mm).Attachprojectormountassembly(A)withtwo#14x2.5"(6mmx65mm)woodscrews(L)

andtwoatwashers(K)asshowningure1.3orgure1.4dependingonjoistorientation.

NOTE: Mounting slots on projector mount assembly allow for 30° (±15°) of swivel adjustment before fully securing

wood screws.

Tighten wood screws (L)using3/8"(10mm)socketoropenendwrenchorphillipsscrewdriveruntilprojector

mount assembly (A)isrmlyattached.

Skip to step 2.

Installation To Wood Joist Ceilings

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tightenwoodscrewssothatprojectormountassemblyisrmlyattached,butdonotovertighten.Overtightening

can damage the screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Makesurethatmountingscrewsareanchoredintothecenterofthestud.Theuseofan"edgetoedge"studnder

is highly recommended.

• Hardwareprovidedisforattachmentofmountthrough5/8"thicknessdrywallorplasterintowoodstuds.

WARNING

WOOD JOIST

g. 1.3

g. 1.4

1 2 3 4 5 6 7 8 9 10 11

No comments

Epson ELPMBPRG User Manual Page 5