Epson FX-100 User Manual download pdf (Page 128)

off, either by changing DIP switches or by sending the printer ASCII

codes as summarized below.

Switch 2-2

When on; activates the beeper; when off,

deactivates it

Switch 1-3

When off, makes the paper-out sensor active;

when on, deactivates it

Switch 2-3

When off, turns the skip-over-perforation

feature OFF; when on, produces an auto-

matic 1-inch skip over every perforation

Check to see if you want to reset any switches before going on to

Chapter 9.

Here are the commands we covered in this chapter:

CHR$(12)

Produces a form feed; CHR$(140) is the alter-

nate, high-order version

CHR$(27)“C”CHR(0)CHR$(n)

Sets the form length to n inches, where n is

1 - 22

CHR$(27)“C”CHR$(n) Sets the form length to n lines, where n is

1 - 127

CHR$(27)“N”CHR$(n)

urns the skip-over-perforation feature ON,

set to n lines, where n is 1 to less than the

current form length in lines. Is cancelled by

CHR$(27)”@” and CHR$(27)“C” as well as

CHR$(27)“O”

CHR$(27)“8”

CHR$(27)"9"

CHR$(27)“@”

Turns the automatic skip-over-perforation

feature OFF

Turns the paper-out sensor OFF

Used in conjunction with CHR$(27)“8”,

turns the paper-out sensor back ON

The Reset Code resets the form length to 11

inches, the top of form to the current line, and

the skip-over-perforation to the DIP switch

setting

111

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 267 268

No comments

Epson FX-100 User Manual Page 128