Epson PowerLite 450W Installation Guide download pdf (Page 26)

H Adjust the vertical position

(1) Adjust the vertical position, then tighten the two M8 x 15 mm hexagon socket head cap

bolts on the sides of the setting plate (

A).

(2) Tighten the two M8 x 45 mm hexagon socket head cap bolts at the bottom of the setting

plate to support your vertical adjustment (

B).

The projected image is raised or lowered accordingly. After you make this adjustment, you may need to

readjust the vertical tilt, as described on page 25.

I Adjust the forward/backward slide

Loosen the four screws and adjust the slider of the setting plate.

After you finish making all of the adjustments in steps

E to I, tighten the screws.

J Turn off the display of the test pattern or computer image

Press the Esc button on the remote control or control panel to turn off the test pattern.

M8 x 45 mm

hexagon socket

head cap bolts (2)

Screws (4)

Tighten all screws firmly. If the screws are not tightened firmly, the projector or setting plate

may fall and cause personal injury or property damage.

Warning

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

No comments

Epson PowerLite 450W Installation Guide Page 26